why do all matlab actuators examples use force as input source?.in real, force is output of actuators.

Question

adhavan d 2024-3-21

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2097146-why-do-all-matlab-actuators-examples-use-force-as-input-source-in-real-force-is-output-of-actuator

评论： Sam Chak 2024-3-21

采纳的回答： Vasco Lenzi

why do all matlab actuators examples use force as input source?.in real, force is output of actuators.

in my project,actuator's output is force.so,i can't use force as input souce for FEM based linear actuator.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Sam Chak 2024-3-21

I'm uncertain since no examples have been provided. However, one possibility is that the input to the actuator is a Commanded Force signal, which is sent from the Controller software.

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Vasco Lenzi 2024-3-21

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2097146-why-do-all-matlab-actuators-examples-use-force-as-input-source-in-real-force-is-output-of-actuator#answer_1428896

编辑：Vasco Lenzi 2024-3-21

Hi, can you point out the examples you are referring to? Most of our highest fidelity examples, including FEM based blocks, don't have force as an input. You setup a supply circuit, connect a motor model, and the only time you have force is when you are "mimicking" the load by suppliying a constant force as the load. Is this what you are referring to? This is what happens in real life as well in testbenches, where the load is a set force (or torque).

You can as well replace the load from a constant source with a model of your mechanisms to be more realistic.

Like in this example, where the load is a mass, and the force is read, not given as an input:

https://www.mathworks.com/help/sps/ug/three-phase-pmlsm-drive.html