The following error occurred during deployment to your hardware board: The generated code exceeds the available memory on the processor. It uses 137.9% of available program

25 次查看（过去 30 天）
Adeleke
Adeleke 2024-3-25
回答： Shreeya 2024-7-4
The image below shows the error I encounter while trying to Run on board (Monitor & Tune). I am using Arduino Uno R3 board and MG995R servo motor for the test. Nevertheless if I deploy this very simple simulink block to arduino, it will deploy and run perfectly. What could I change?

请先登录，再回答此问题。

回答（1 个）

Shreeya
Shreeya 2024-7-4
Hey
I suppose the error message suggests that you need to optimize the generated code such that it can be executed on the processor. I'm linking the document which lists the various strategies available for the memory optimization of the code:
https://www.mathworks.com/help/coder/optimize-size-of-generated-code.html

类别

在 Help Center 和 File Exchange 中查找有关 Run on Target Hardware 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by