The following error occurred during deployment to your hardware board: The generated code exceeds the available memory on the processor. It uses 137.9% of available program

Question

Adeleke 2024-3-25

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2098376-the-following-error-occurred-during-deployment-to-your-hardware-board-the-generated-code-exceeds-t

回答： Shreeya 2024-7-4

The image below shows the error I encounter while trying to Run on board (Monitor & Tune). I am using Arduino Uno R3 board and MG995R servo motor for the test. Nevertheless if I deploy this very simple simulink block to arduino, it will deploy and run perfectly. What could I change?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Shreeya 2024-7-4

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2098376-the-following-error-occurred-during-deployment-to-your-hardware-board-the-generated-code-exceeds-t#answer_1481081

Hey

I suppose the error message suggests that you need to optimize the generated code such that it can be executed on the processor. I'm linking the document which lists the various strategies available for the memory optimization of the code:

https://www.mathworks.com/help/coder/optimize-size-of-generated-code.html