Hi,
I encountered a similar issue while working with the SerDes Toolbox in Simulink when compiling my Tx model. Here is a workaround that I used, which might help resolve the problem:
1) Load a Blank Model: Open a new blank model in the SerDes Designer. This model should compile without any issues.
2) Export and Copy Configurations:
a. Export this blank model to Simulink.
b. Use the ‘Model Explorer’ to copy the configuration settings from this blank model.
3) Apply Configurations to Your Model:
a. Open your original model that is causing the error.
b. Paste the copied configurations into your model using the ‘Model Explorer’.
4) Export the AMI Model: Try exporting the AMI model again.
5) Adjust the Stimulus Block:
a. If the error persists, locate the "stimulus" block in your model.
b. Check the 'custom stimulus' option and enter `[0 1 0]` as the value.
c. Uncheck the 'custom stimulus' option.
6) Export Again.
This workaround addresses issues related to configuration parameters, which appear to be the root cause, especially since the problem persists even with default SerDes Toolbox blocks. If the issue continues, consider reaching out to MathWorks support for further assistance.
Hope this helps!
