To configure the SPI module for the TCAN4550 chip, ensure you use the register addresses specific to the TCAN4550, not those of the 28335 microcontroller.
Configuring the SPI Module:
Access Hardware Board Settings:
- Navigate to the Hardware Implementation settings and expand the 'Target hardware resources' section.
- You will find options for SPI channels such as SPI_A, SPI_B, and SPI_C.
Set Parameters:
- Configure the mode, baud rate, pin assignments, clock assignments, and chip select settings as needed.
Data Transmission:
- Use the Tx port to send data to the TCAN4550. Ensure that the data is correctly formatted according to the TCAN4550's register specifications.
- Use the Rx port to receive data from the TCAN4550.
Example Setup: When writing to a specific register, format the data appropriately for the TCAN4550. For example, if the TCAN4550 requires a specific command and address format, ensure your Tx data adheres to this format.
Hope this helps!
