Hi,
The error message you're encountering suggests that there's an issue with the setup or initialization process for the ADAR1000 component in your ADI Phaser project. Make sure that all hardware connections are properly configured, and the power supply to ADAR1000 is as per required. If the issue still persists, here could be some possible reasons and the steps you can take to resolve the same:
- Problems with SPI Communication: The error could be due to issues with SPI communication between your control platform (e.g., an FPGA or microcontroller) and the ADAR1000. Verify that the SPI settings (clock speed, mode, bit order) match the requirements of the ADAR1000. Also ensure that the SPI signals have good integrity and are not degraded due to long cables or improper termination.
- Software Configuration: The error could also stem from a software or firmware configuration issue.Ensure you are using the correct version of the Analog Devices library for your hardware. Compatibility issues between the library and hardware can lead to such errors. Also make sure to review the initialization sequence in your code. The ADAR1000 may require a specific sequence of commands to be properly initialized.
In addition to the above, you can use diagnostic tools or functions provided by the Analog Devices library or your development environment to check the status of the SPI bus and the ADAR1000. This might provide more insight into what is going wrong.
