Could not connect to Zynq hardware board using IP address 192.168.1.101.

10 次查看（过去 30 天）
koushik
koushik 2024-4-9
评论： Manikanta Aditya 2024-4-9
Could not connect to Zynq hardware board using IP address 192.168.1.101.
Check that your device is connected to a LAN or direct network connection accessible from the MATLAB development computer
  2 个评论
Manikanta Aditya
Manikanta Aditya 2024-4-9
As mentioned, try checking your connection as well, and ensure that the USB cable is plugged into the ‘USB-to-UART’ port of the hardware and the power switch is turned on. If this error persists, switch off the hardware, wait for 10 seconds, switch on the hardware and then repeat this step.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Targeting FPGA & SoC Hardware 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by