need name of the block in simscape tools

2 次查看（过去 30 天）
Hamid Ullah
Hamid Ullah 2024-4-16
编辑： Sam Chak 2024-4-16
Good day
In this scheme can pplease tell me what is or what is the name of block which one is connected from Motor output to the second input of the scope block?
best regards

请先登录，再回答此问题。

回答（1 个）

Sam Chak
Sam Chak 2024-4-16
编辑：Sam Chak 2024-4-16
Hi @Hamid Ullah
It appears to be a Simscape block diagram. Simscape components cannot be connected directly to the Scope block. To measure the output of the motor, you would need to use a Motion Sensor and convert the physical state (PS) signal into a Simulink signal. This conversion is necessary in order to display it in the Scope.
The w block is a Masked Subsystem block.
  1 个评论
Sam Chak
Sam Chak 2024-4-16
移动：Sam Chak 2024-4-16
You're welcome, @Hamid Ullah. However, please note that I manually constructed the block configuration shown in the image using three components:
  • Ideal Rotational Motion Sensor
  • Mechanical Rotational Reference
  • PS-Simulink Converter
I did not refer to the actual Simulink example of "Closed-loop pump control with Flexible Drive Shaft" when creating the masked subsystem. If you would like to view the example as suggested in the provided link, you can use the following command:
openExample('simscapefluids/ClosedLoopPumpControlWithFlexibleDriveShaftExample')

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Composite Components 的更多信息

标签

产品


版本

R2023b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by