How can I specify the pressure and or the temperature for a specific point in a thermal liquid network ?

3 次查看（过去 30 天）
Karim Darwich
Karim Darwich 2024-4-26
评论： Manikanta Aditya 2024-4-29
Hello everyone
I was wondering wether using a reservoir (TL) is a good choice or not. Thank you in advance

请先登录，再回答此问题。

采纳的回答

Manikanta Aditya
Manikanta Aditya 2024-4-29
编辑：Manikanta Aditya 2024-4-29
Hi,
I felt that using Pressure and Temparature sensor is also helpful, but yes after little research on your comment on the told point. I feel Reserviour(TL) is a good choice. It acts as a large body of fluid at a specified pressure and temperature. It can supply or absorb fluid as needed to maintain its specified pressure and temperature.
Hope this helps.
  3 个评论
显示 1更早的评论
Manikanta Aditya
Manikanta Aditya 2024-4-29
Some more pointers:
  • In complex thermal liquid networks, it might not be feasible to model every single component. The Reservoir block can represent a large body of fluid, simplifying the model and reducing computational complexity.
  • The Reservoir block can be used to test the response of the system to different pressures and temperatures. By changing the conditions of the Reservoir block, you can observe how the rest of the system reacts, which can be very useful for control and testing purposes.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Simscape Fluids 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by