Hi,
The error you are encountering likely stems from the incorrect use of the ‘setBlockParameter’ function. Here are the key points to address the issue:
1. Incorrect Use of ‘setBlockParameter’:
The function 's = setBlockParameter(s, blkpath, blkparam, paramval)’ is used to set the value of a block parameter ‘blkparam’ as ‘paramval’ for the block at ‘blkpath’ on a ‘Simulink.SimulationInput’ or ‘Simulation’ object ‘s’. It seems that in your case, ‘in’ used in the ‘localResetFcn’ is not defined as a ‘Simulink.SimulationInput’ or ‘Simulation’ object. Here is an example of how you can correctly define a ‘Simulink.SimulationInput’ object and modify a parameter value:
mdl = "modelName";
% Create a SimulationInput object for this model
simin = Simulink.SimulationInput(mdl);
% Modify block parameter value
simin = setBlockParameter(simin, "modelName/Gain", "Gain", "7");
% Simulate the model
out = sim(simin);
For more details, refer to this documentation:
2. Simulink Model Consistency:
Ensure that the block path and parameter names you are using are consistent with those defined in your Simulink model. Verify the exact names and paths by checking them directly in the Simulink model to avoid any discrepancies. You can determine the path name of a block by choosing the desired block in your Simulink model and then entering the command ‘gcb’ in the MATLAB Command Window. This command will return the path name of the currently selected block. For more information on the ‘gcb’ command, you can refer to this documentation:
By following these steps, you should be able to resolve the error and successfully modify block parameters in your Simulink model.
