Why am I getting "double" datatype automatically for every simulink block?

32 次查看（过去 30 天）
Kaustubh
Kaustubh 2024-5-14
编辑： Divyanshu 2024-8-1
Upon making minor changes in the simulink model, the simulink blocks are automatically being assigned with the datatype double. Since all the blocks having this datatype, the "DatatypeOverride = Off" option as well as locking the output datatype option are not working. Is it possibly because of the introduction of switch-case block or something else? Kindly help me out.
Thank you.
  2 个评论
Fangjun Jiang
Fangjun Jiang 2024-5-16
The default datatype in MATLAB and Simulink is double. Was it showing something different before making "minor changes"? Were you able to restore and show the data type other than all doubles?
Sanghyo Jeong
Sanghyo Jeong 2024-7-2
编辑：Sanghyo Jeong 2024-7-2
I am also getting every variables as double. Casting block doesn't work and affect on any signals.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Divyanshu
Divyanshu 2024-8-1
编辑：Divyanshu 2024-8-1
Hi Kaustubh,
A possible reason that it shows 'double' datatype for all the blocks after adding a 'Switch' block can be the value of parameter 'Output data type' under 'Signal Attributes' tab of block parameters.
If the value is 'Inherit: Inherit via internal rule' then due to attribute propagation it shows 'double' for all the blocks.
This propagation creates an internal loop in the model. To break this loop you can add one or more Signal Specification block.
You can also refer the following MATLAB answer thread which addresses a similar issue:
https://www.mathworks.com/matlabcentral/answers/1928025-why-is-my-simulink-data-type-randomly-changing
Hope it helps!

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by