How to access / configure Simscape parameters from Multiple Simulations configuration?

Question

Mark 2024-6-3

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2125061-how-to-access-configure-simscape-parameters-from-multiple-simulations-configuration

编辑： Abhinav Aravindan 2024-9-13

I am looking at the Fuel Cell / EV reference application (as an example) and multiple simulations.

The model includes Simscape blocks. Can I configure/access parameters of those Simscape blocks from the Multiple Simulations dialog? (I can successfully configure Simulink parameters (for example, vehicle mass) within the Multiple Simulations dialog.)

As an example, in the model, under FCElectricPlant, there is a DC-DC Converter Simscape model. There is an "efficiency" setting under "Losses" that I would like to change using a Multiple Simulations setting.

Thanks!

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Abhinav Aravindan 2024-9-13

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2125061-how-to-access-configure-simscape-parameters-from-multiple-simulations-configuration#answer_1516165

编辑：Abhinav Aravindan 2024-9-13

Hi Mark,

To access the “Percentage efficiency at rated output power” parameter, you can follow the steps provided below:

Find the parameter name by hovering over the value. The parameter name for “Percentage efficiency at rated output power” is “eff_rated”.
Change the parameter to a “Run-Time” parameter.
In the “Multiple Simulations” panel, add a “Block Parameter” in the “Design Study” tab and enter the block path, parameter name, and values for your simulation.