Inverter DC Capacitor Voltage Control

2 次查看（过去 30 天）
xin
xin 2024-6-15
回答： Zuber Khan 2024-7-16
Using PI to control the DC capacitor voltage of the inverter, but there are pulses from 0.4 seconds. I don't know what the cause is.
  1 个评论
Sam Chak
Sam Chak 2024-6-15
Do you have the mathematical model of the DC capacitor voltage of the inverter?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Zuber Khan
Zuber Khan 2024-7-16
Hi,
I understand that receiving pulsating DC capacitor voltage is not a normal behaviour in case of an inverter. Since you have neither shared the mathematical model nor the Simulink model, it is difficult to find the exact reason behind this issue.
However, there are some general troubleshooting steps as follows that you can try at your end:
1) Check if you are correctly tuning the PI Controller parameters. Improper tuning of the PI controller parameters (proportional gain (K_p) and integral gain (K_i)) can lead to instability or oscillations.
2) Analyze the step response of your system with the PI controller to ensure it is stable and meets required performance criteria.
3) Conduct a frequency response analysis to spot any resonant frequencies that might be causing the oscillations.
4) Run simulations of your system under different conditions. This can help you pinpoint the cause of the pulses and fine-tune the controller parameters accordingly.
5) Make sure your system model accurately reflects the real-world system, including any delays and non-linear characteristics.
I hope it helps.
Regards,
Zuber

类别

在 Help Center 和 File Exchange 中查找有关 Switches and Breakers 的更多信息

标签

产品


版本

R2018b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by