清空筛选条件
清空筛选条件

C2000 ePWM down-count after syncronized in up-down counter

22 次查看（过去 30 天）
Arifin
Arifin 2024-6-18
编辑： Divyanshu 2024-7-30，6:43
I want to make two PWM module that the counting direction is reverve as picture bellow.
  1. ePWM 1 is start counting Up-down-Up,
  2. ePWM 2 is start counting at Down-up-Down.
I set the PWM module syncronized = zero, without any Phase shifted (TBPHS=0). However, i can not get the desured result.
with kindly, need assistance for set this ePWM matter.
  2 个评论
Aman Banthia
Aman Banthia 2024-6-18
You have set the counting mode to 'Up-Down' in both the ePWM Block Parameters. Changing that might help you get the desired result.
Arifin
Arifin 2024-6-20
@Aman Banthia
Sorry, but it was set up-down counting mode at both.
please see my question figure.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Divyanshu
Divyanshu 2024-7-30，6:18
编辑：Divyanshu 2024-7-30，6:43
Hi Arifin,
Although in the block parameters of ePWM block you have specified 'Counting-Mode' as 'Up-Down' for both ePWM blocks but the parameter 'Synchronization action' is different for both the blocks.
Now as per the snapshot of Block Parameters for 'ePWM4' block because 'Synchronization action' is 'Set counter to phase value specified via dialog' another parameter 'Counting direction after phase synchronization' is enabled.
The value for 'Counting direction after phase synchronization' is 'Count down after sync' so I guess this is the parameter which is forcefully starting count from down. So if you set 'Synchronization action' to 'Disable' then both plots might become identical.
You can refer the following documentation links for more details about these parameters:
Hope it helps!

类别

在 Help Center 和 File Exchange 中查找有关 Texas Instruments C2000 Processors 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by