customlized AMD rfsoc board support package configure error

Question

忆雪 2024-6-23，7:54

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2131151-customlized-amd-rfsoc-board-support-package-configure-error

评论：忆雪 2024-6-25，2:45

createRFSOC27DR.pdf

We build a custom hardware board base on AMD rfsoc 27dr, follow the

success build a boardSupportPackage, and install it in mathworks R2023b system, but when apply this custom board to the 'soc_rfsoc_datacapture' case, can't pass configure steps. The simulink report :

Error:A dot '.' indexing expression produced a comma-separated list with 2 values where only a single value is allowed.

I am sure this is ok if we choose the hardware board 'Xilinx Zynq ultraScale+ RFSoC ZCU111...', that means, the error is maybe due to our boardSupportPackage.

The attached file is the boardSupportPackage create script.

best regards for reply.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

R 2024-6-24，11:08

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2131151-customlized-amd-rfsoc-board-support-package-configure-error#answer_1476301

在 MATLAB Online 中打开

modified_script_BSP.m

Hi @忆雪,

I can see you are following the steps at https://www.mathworks.com/help/soc/ug/create-board-support-framework.html for creating a custom board support framework.

There are a few things you can verify and check to resolve this error.

Firstly, in the error message, lists 'Xilinx Zynq ultraScale+ RFSoC RFSOC27DR Board Support package' whereas in the first step the name is 'RFSOC27DR Board Support package'. You can verify and use a consistent target name in all places.

Rarely this can also be caused due to folder not being added on the MATLAB path. Please ensure that the folder containing board support package files are added to the MATLAB path:

addpath('D:\rfsoc27dr_boardSupportPackage')

After making changes to custom target files, you need to refresh Simulink customizations.

sl_refresh_customizations

I have tried and attached the running script as 'modified_script_BSP.m'.

Hope it helps!

4 个评论
显示 2更早的评论隐藏 2更早的评论

忆雪 2024-6-25，2:33

Hi RS,

I carefully check the procedure to reach the last Configure & deploy... step, understand your addpath('D:\rfsoc27dr_boardSupportPackage'), that means, don't need to install the packaged file rfsoc27dr_boardSupportPackage.mlxtb.

This is the reason for simulink report A dot '.' indexing expression produced a comma-separated list with 2 values where only a single value is allowed. I thank the mathworks see two boad support package with the same name.

But now, new error appear: error:Hardware board names for the top model and processor model must match.

Would your can give some hints more?

Thanks.

忆雪 2024-6-25，2:45

addtionally, I found that the same 'soc_rfsoc_datacapture' case only suit zcu111 board, even change to zcu108 don't work with 'error : Hardware board names for the top model and processor model must match'

请先登录，再进行评论。