The encoder counter and speed display are wrong

4 次查看（过去 30 天）
fred liu
fred liu 2024-6-26
回答： UDAYA PEDDIRAJU 2024-8-30
I'm using R2024a and Embedded Encoder Support Package for Infineon AURIX TC3x Microcontrollers inside the add on.
And using the encoder block and running in KIT_A2G_TC387_5V TFT board ,and use scope to observe the output.
The results and settings are as shown below.
1.hardware setting
2-1 encoder setting
2-2 encoder setting
3.scope setting
4.result
from top to the bottom is count,direction,and rad/s.

请先登录，再回答此问题。

回答（1 个）

UDAYA PEDDIRAJU
UDAYA PEDDIRAJU 2024-8-30
Hi Fred,
To address the incorrect encoder counter and speed display:
  1. Check Hardware Configuration: Ensure all hardware settings are correctly configured for the KIT_A2G_TC387_5V TFT board.
  2. Verify Encoder Settings: Double-check the encoder settings, including resolution and signal type, to match your hardware specifications.
  3. Scope Configuration: Review the scope settings to ensure proper signal scaling and time base alignment.
  4. Calibration: If discrepancies persist, calibrate the encoder and verify connections to rule out hardware issues.
These steps should help resolve the inaccuracies in your encoder counter and speed display.

类别

在 Help Center 和 File Exchange 中查找有关 Peripheral Management 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by