Inputs and process for thermal model discretization for battery spatial temperature estimation
18 次查看(过去 30 天)
显示 更早的评论
Hi,
I am building a cell and module level battery model. I am using ECM for electrical model and want to use 3D discretized thermal model which I am building in Ansys.
Is there a way to connect this thermal model from ansys to simscape for spatial temperature distribution analysis? Also, if possible, how can it be done on a module level?
I am refering this example - https://www.mathworks.com/help/simscape-battery/ug/battery-spatial-temperature-variation-during-fast-charge.html
0 个评论
回答(1 个)
Yifeng Tang
2024-8-20,13:49
If you are thinking about running the ANSYS simulation and Simscape at the same time, with some kind of interface to pass along information, I would discourage you from doing that. Usually FEA and CFD simulation runs much slower than system-level simulation like Simscape, and you may not get what you envisioned.
If you are OK with running some simplified artefacts generated from ANSYS in Simulink, you can check out this page on reduced-order modeling: https://www.mathworks.com/discovery/reduced-order-modeling.html
I believe some of the examples are similar to what you are trying to do.
I would suggest that you start with less number of discretization, just to get a taste of the workflow and impact on the simulation speed.
另请参阅
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!