Problem while using HDL Workflow Advisor in MATLAB for the standard LED blink example, specifically targeting the Versal VCK190 board

1 次查看（过去 30 天）
Gaurav
Gaurav 2024-8-20
编辑： Saurabh 2024-8-22
I am new to FPGA programming and attempting to use the HDL Workflow Advisor in MATLAB for the standard LED blink example, specifically targeting the Versal VCK190 board. I am encountering a couple of issues:-
  1. The Reference Design option in the Set Target section of the HDL Workflow Advisor is not enabled or highlighted (it defaults to "visible").
  2. The Reference Design Parameters options, such as Insert AXI Manager and FPGA Data Capture, are missing or unavailable.
I am using Ubuntu 18.04.6 LTS, MATLAB R2022a, and Vivado 2020.2. I am referring to the MathWorks documentation for guidance: Getting Started with Targeting Xilinx Versal ACAP Platform.
Could you provide steps to troubleshoot these issues?

请先登录，再回答此问题。

回答（1 个）

Saurabh
Saurabh 2024-8-22
编辑：Saurabh 2024-8-22
Hi Gaurav,
It seems the Reference Design parameters options are absent and you cannot change Reference Design to Default System. I looked over the release notes to see if this problem had been resolved, and the r2022b release has this rectified. The same information can be found here:
Therefore, installing the r2022b release can be a remedy for this problem.

类别

在 Help Center 和 File Exchange 中查找有关 Xilinx Zynq Platform 的更多信息

标签

产品


版本

R2022a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by