Hi Radavid,
I see that you are encountering issues while attempting to run a Processor-in-the-Loop (PiL) simulation for a discrete filter on an STM32 Nucleo L476RG, after converting the filter to a referenced model.
Here are some steps you can take to troubleshoot and resolve the issue:
1.Check Model Configuration:
- Referenced Model Settings: Ensure that the referenced model is correctly configured for your hardware.
- Open Simulation > Model Configuration Parameters > Solvers and verify that the Solver options are appropriate for your target hardware.
- Code Generation Settings: Verify that the code generation settings in the Configuration Parameters are properly configured for the target hardware
- Check the model configurations for STM Nucleo boards at the following documentation https://www.mathworks.com/help/rtw/nucleo/ref/hardware-implementation-pane-2.html
2. Try building the referenced model separately to see if any specific errors occur during the build process. This can help isolate whether the issue is with the model itself or with the integration into the larger model.
3. Consider creating a model for the filter instead of converting an atomic subsystem to model.
For more information about integrations with STM Nucleo boards, you can refer the following documentation:
Hope this helps!
