清空筛选条件
清空筛选条件

single phase and three phase dynamic load

6 次查看（过去 30 天）
Samir
Samir 2011-11-17
编辑： Sebastian Castro 2015-11-6
Hello all, My first question is why single phase dynamic load is not in simulink library? Another question, when i simulate single phase dynamic load in any mode(continuous,discrete or phaser)its too slow and if i run for longer time, the memory allocated for matlab is full and doesn't for forward. is there any solution for it? but this is not the case with three phase dynamic load. i am quit surprise with this.
is there any way to use three phase dynamic load for single phase dynamic load?
Many thanks
  2 个评论
Tony Castillo
Tony Castillo 2015-11-6
Hey my friend I am having the same problem than you had in the past, could you share with my how did you surpassed it?, because i am mired with it. I would appreciate any the colaboration on it.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（2 个）

cr28
cr28 2012-8-13
Samir,
All i can say is when i simulated a 3-phase dynamic load in phasor mode, the simulation was quick.....a lot quicker than continuous mode.
matan
matan 2012-9-11
where is there a singal phase dynamic load?
  1 个评论
cr28
cr28 2012-9-12
there is NO single phase dynamic load that i know of...u can build one though using other elementary blocks.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Electrical Sensors 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by