Simscape Multibody Model with Elastic tooth mesh

6 次查看（过去 30 天）
Thomas Scheu
Thomas Scheu 2024-9-16
回答： Thomas Scheu 2024-9-17
Hi everybody,
I want to simulate an elastic tooth mesh within my simscape multibody model. The model is very simple and consists only two gears. The model works fine with the "Common Gear Constraint" block, but I want to simulate spring and damping effects. Therefore I added a Torsional Spring-Damper which I connected to the model via a Rotational Multibody Interface.
Error:An error occurred during simulation and the simulation was terminated
Caused by:
['Test_ElastischerZahneingriff_1/Solver Configuration']: Initial conditions solve failed to converge.
Nonlinear solver: Linear Algebra error. Failed to solve using iteration matrix.
The model may not give enough information to make it possible to solve for values of some of its variables. Specific advice is given below.
all components and nodal across variables involved
Tie variable 'Torsional_Spring_Damper.R.w' (Rotational velocity) to a definite value, for example by connecting an appropriate domain reference block.
Dependency found among topology equations. Check for missing reference node.
Is anybody out there who can help me fixing this error?
You can see the model in the pictures.
Thank's everybody for any helpful comment....
Kind regards,
Thomas

请先登录，再回答此问题。

采纳的回答

Jaimin
Jaimin 2024-9-16
Hi Thomas Scheu,
It appears from the attached model image that the “Mechanical Rotational Reference” block is missing. Please connect it with the “Torsional Spring-Damper” block to resolve the error.
For more information on “Mechanical Rotational Reference” block please refer following MathWorks Documentation
https://www.mathworks.com/help/simscape/ref/mechanicalrotationalreference.html
I hope this will be helpful.
  1 个评论
Thomas Scheu
Thomas Scheu 2024-9-16
Thank you very much for your help! Now the error is gone, but the physical connection between the two gears does not seem to be right (as mentioned in the answer below). Do you know anything I did wrong in connecting the to gears via the torsional spring-damper?
Kind regards

请先登录，再进行评论。

更多回答（2 个）

Thomas Scheu
Thomas Scheu 2024-9-17
I fixed the problem by adding an additional common gear constraint. Thanks.
Thomas Scheu
Thomas Scheu 2024-9-16
Hi Jaimin,
thank you very much for your fast respond. With your help, the simulation now starts without the error. Thank you very much.
Now the problem is that the elastic tooth mesh seems to be physically wrong. I made a screenshot to explain the problem:
I made one gear transmission with the common gear constraint block (left gear), and one with the torsion spring damper (right gear). When I compare the rotational speeds of both gears, the one connected via the torsion spring damper seems to be totally wrong (the ratio should be 1:2 - so the speed of the left gear is rigth).
I tried many combinations of the parameters of the torsional spring-damper, but nothing could come close to accurately reflecting the transition.
Is there anything to add except the torsional spring-damper to let the system "know" the physical dependence of the two gears?

类别

在 Help Center 和 File Exchange 中查找有关 Assembly 的更多信息

标签

产品


版本

R2024a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by