Adsorption process in Simulink
显示 更早的评论
How to create a switch command between adsorption and desorption in Simulink?
2 个评论
Rahul
2024-10-4
Hey @Ababacar Thiam, can you share your Simulink Model, or describe your use case, that'll help in better understanding the isssue.
Ababacar Thiam
2024-10-4
采纳的回答
Altaïr
2024-10-8
0 个投票
To switch between the two subsystems (adsorption and desorption) based on a control signal, the ‘Switch’ block can be used. The control signal can be generated in a couple of ways:
- Using ‘Relational Operator’ and ‘Logical Operator’ blocks if the switching logic is simple.
- For more complex switching logics, a ‘Stateflow’ chart can be used.
You can learn more about the ‘Switch’ block in the following documentation page.
Here’s an example for the ‘Switch’ block that outputs the absolute value of a biased sine wave. The below model switches between ‘subsystem1’ and ‘subsystem2’ depending on the value of ‘controlSignal’. 
The output seen in the scope would be as follows:
You can refer to the attached model for further assistance. To switch between several subsystems, the ‘Multiport Switch’ block can be used. Feel free to check out the following documentation page.
I believe this will assist you!
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 General Applications 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
