I cannot flip manual switch while in monitor and tune

40 次查看（过去 30 天）
Malek
Malek 2024-10-8
编辑： Vorrapath Kokaew 2024-10-29，12:09
Hello,
When running a simulation on an Arduino Mega 2560 through monitor and tune, I cannot change the position of any manual switch in my block diagram. I am running the simulation on the board and the sim is running on external mode through XCP on Serial. Any help would be much appreciated.

请先登录，再回答此问题。

采纳的回答

Amal Raj
Amal Raj 2024-10-28，10:08
Hi Malek, I think you are faced with a bug in 2024b.
The workaround would be to update Default Parameter Behavior parameter drop-down value to Tunable in the config set.
This will solve the issue you are facing. You can even try working with other versions of MATLAB, and you should be fine.
Regards,
Amal
  1 个评论
Vorrapath Kokaew
Vorrapath Kokaew 2024-10-29，12:04
编辑：Vorrapath Kokaew 2024-10-29，12:09
So, do I. I use ESP32 with arduino package that message shown Cannot change the model '.......' while the simulation is running. Anyway, I already follow the Amal Raj suggestion that WORK!!!!
Thank a lot

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息

标签

产品


版本

R2024b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by