TI Radar Toolbox with DCA1000EVM Connection - Continuous error occurs when attempting to connect with an Ethernet cable

39 次查看（过去 30 天）
JeungWoo Ham
JeungWoo Ham 2024-10-16
评论： Gayatri Menon 2024-11-14，10:24
This is our hardware Setting
We are using IWR6843ISK with DCA1000EVM capture board
This pictures are our device manager and Fixed IPv4 Settings
This is our Inbound and Outbound Firewall settings
We followed many guide to connect DCA1000EVM capture board but we are contiunously experiencing error like this
How can we solve this error?

请先登录，再回答此问题。

回答（1 个）

Deep
Deep 2024-10-23
Your network adapter and Windows Firewall settings indicate that the local IP address of your Windows machine is "192.168.33.30," while the IP address of your remote device (DCA1000EVM) is "192.168.33.180." However, your MATLAB setup for the DCA1000EVM is currently attempting to connect to your local Windows machine. Please update the configuration to connect to "192.168.33.180" instead.
For additional troubleshooting assistance, please refer to this guide on setting up and connecting with the DCA1000EVM: https://www.mathworks.com/help/radar/troubleshooting-dca1000evm.html
  3 个评论
显示 1更早的评论
Gayatri Menon
Gayatri Menon 2024-11-14，10:24
Hey,
Can you try the below:
  1. Run the ipconfig command in the Command Prompt and share the output.
  2. Try disconnecting the Radar from the DCA1000 and then:
Connect the DCA1000 to a power supply
Ensure that switch SW3 is set to DC_JACK_5V_IN and SW2.5 is in the SW_config position
Wait for 10-15 seconds, then attempt the test connection again.
3. Try disabling all other network connections, including Wi-Fi, except for the connection to the DCA1000 network. (This is the least probable cause, try this if step 2 doesn’t work).

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Waveform Design and Signal Synthesis 的更多信息

标签

产品


版本

R2024b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by