Issue during completing Design Filter with Cutoff Frequencies Task 1 in Signal Processing Course

37 次查看（过去 30 天）
Teodora
Teodora 2024-11-6，16:40
编辑： Teodora 2024-11-6，20:37
Hello,
I got stuck at this point while completing the Signal Processing course. In the design filter I select bandpass FIR filter, then change the Frequency units to Hz and set the sample rate to fs as it can be seen on my attached picture. Yet when i submit the task, I get error at the Design Filter with Cutoff Frequencies test question. If I click on 'See solution' the necessary part is grey, and can't be viewed. Can you please help me with this issue so I can continue the course? Thank you.

请先登录，再回答此问题。

回答（1 个）

Abhimenyu
Abhimenyu 2024-11-6，18:30
Hi Teodora,
I understand that you are facing an issue while completing the 'Design Filter with Cutoff Frequencies' Task 1 in 'Signal Processing with MATLAB' Course.
The Task states to change the sample rate of the variable designedFilter. However, in the dialogue box of Design Filter, the parameters are set for the variable designedFilter2 as shown by this image:
To resolve the issue, please edit the variable name from designedFilter2 to designedFilter as given by this image:
I hope this helps!

类别

在 Help Center 和 File Exchange 中查找有关 z-transforms 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by