Some Constant blocks not tunable in Simulink External Mode

9 次查看（过去 30 天）
Thomas Marullo
Thomas Marullo 2015-5-14
评论： Mike Buba 2021-10-24
I'm running 2014a and I am using a Simulink model in External run mode. I have a few constant blocks I'd like to change the value of however they aren't all tunable during run time. For instance, Constant1 and Constant2 are connected to a Subsystem and Constant1's block properties are greyed out during runtime however Constant2's block properties I can change during runtime. They are virtually identically blocks wrt properties. Not sure what's going on here.
  3 个评论
显示 1更早的评论
Mike Buba
Mike Buba 2021-10-24
I noticed the not tunable constants were directly or indirectly, via subtract block (reference - feedback), connected to the PID Controller block.
When I implemented my PI block (similar to as it is under the PID Controller's mask), I could tune them.
Same is with Discrete-Time Integrator.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Sebastian Castro
Sebastian Castro 2015-5-14
Are those constant blocks using hard-coded numerical values or are they variables (either numeric or Simulink.Parameter objects?)
Also, without knowing much about your model, I would maybe check your Inline Parameters settings?
- Sebastian
  2 个评论
Thomas Marullo
Thomas Marullo 2015-5-14
编辑：Thomas Marullo 2015-5-14
Thanks, Sebastian. I've checked the Inline Parameters, which I've never turned on. My model is a closed loop system. The constant blocks use scalar/double variables as the value for the Constant block.
I've attached a screenshot of the model in external mode. I highlighted the block property of two constant blocks. The EQSCaleFactor one is a scalar/double value, (ie. 0.923). The Structure.P0 is a vector double 1x134. Structure.P0 is tunable whereas Integrator.EQScaleFactor isn't. I can't understand why.
Again, no Inline Parameters setting have ever been enabled.
Sebastian Castro
Sebastian Castro 2015-5-14
Strange... so both "Structure" and "Integrator" are MATLAB structures, then?
Which of those blocks in your screenshot are the constant blocks in question, and what do they feed into?

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by