Connecting Hardware To Host Computer

6 次查看（过去 30 天）
Sri Janani
Sri Janani 2024-11-28
评论： Abhishek Kumar Singh 2025-2-28

Hello Everyone, I am trying to connect ADI RF SOM to the host computer for my project through Communication toobox support package for Xilinx Zynq Based Radio. I followed every step as prompted by the setup procedure but still in the below step the LEDs are not glowing. I tried every possible step given to resolve this problem but Still the same issue. Is there any other way to solve this issue.

Note: the Board is working fine and the LEDs are also fine
Thanks and Regards
Sri Janani E

  1 个评论
Abhishek Kumar Singh
Abhishek Kumar Singh 2025-2-28
Hi @Sri Janani,
Have you had a chance to go through the troubleshooting steps outlined in this document?
https://www.mathworks.com/help//releases/R2021a/supportpkg/xilinxzynqbasedradio/ug/common-problems-and-fixes.html
Additionally, could you please share the output and behavior you observe when you follow the steps in the guide?
Also, just one more suggestion, I assume you are using the Communications Toolbox Support Package for Xilinx Zynq-Based Radio. This support package is compatible with MATLAB versions from R2014b through R2023b. For MATLAB R2024a and later, support for Xilinx Zynq-Based Radio is provided via the SoC Blockset Support Package for Xilinx Devices. Therefore, if you are using a newer version of MATLAB, please consider using the updated support package.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Texas Instruments C2000 Processors 的更多信息

标签

产品


版本

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by