Switch multiport switch inputs based on time and order from user

5 次查看（过去 30 天）
Yazeed
Yazeed 2024-12-10
编辑： Fangjun Jiang 2024-12-11
I have a multiport switch with 6 inputs in simulink and would like the user to input an order of which inputs to select and for how long, is this possible. For example, the user wants the model to start at input 4 and stay there for 5 seconds, then select input 1 for 10 seconds, and finally select input 3 for 7 seocnds.

请先登录，再回答此问题。

回答（1 个）

Fangjun Jiang
Fangjun Jiang 2024-12-10
编辑：Fangjun Jiang 2024-12-11
There are many ways to do it. The easiest or most flexible way to do it is probably by using a MATLAB Function block. Use a Clock block as an input which provides the simulation time, use if-elseif to determine the timing and provide the output, which could be the direct selection of those 6 inputs, or the index used by the downstream Multi-port Switch block to select the inputs.
Other ways:
  1. Use Relational Operator blocks and Switch Blocks (cascaded)
  2. Use If block and If Action Subsystem block
  3. Use 1-D Lookup Table block
  2 个评论
Yazeed
Yazeed 2024-12-10
编辑：Yazeed 2024-12-10
The issue Im running into using this method is "Simulink cannot propagate the variable-size mode. The multi-port switch expects a fixed-size mode."
Fangjun Jiang
Fangjun Jiang 2024-12-10
编辑：Fangjun Jiang 2024-12-10
Then the output of the MATLAB Function block is not right. It should be a scalar if it is connected to a downstream multiport switch block. Debug the MATLAB Function block alone. Its output should always be a scalar number between 1 to 6 (or 0 to 5 if zero-based).

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

产品


版本

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by