How to Output Updated Parameters Value in ode Integration Process When the odeEvent is triggered ?

8 次查看（过去 30 天）
Chuguang Pan
Chuguang Pan 2024-12-27
回答： charan 2024-12-27
I was working on multi-body systems collision simulation utilize ode MATLAB function and odeEvent function.
The impact between two body was built as a event using odeEvent MATLAB function.
The impact event will change some parameters which are incorporated in the governing equations of motion such as ydot=f(t,y,P).
I want to output the updated parameters when the impact event is triggered using fprintf function in the EventCallback function illustrated as follows :
function [stop,Ye,Pout] = impactEventCallback(te,ye,ie,Pin)
% ... parameters updating process
fprintf("The updated parameters are : %e", Pout)
end
However, when I simulate the impact process, there is no output display.
Can anyone give me some advices about how to output parameters when the impact event is triggered.
  3 个评论
显示 1更早的评论
Chuguang Pan
Chuguang Pan 2024-12-27
@sai charan sampara thanks for your reply, I find that the issue is just as you said. I set the "Response" to "proceed". After I set it to "callback", it worked correctly!

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

charan
charan 2024-12-27
Hi Chuguang,
The call back function is called whenever the event occurs, only if the "Response" parameter is set to "callback". If the "Response" parameter is set to "proceed" then the solver logs the event and continues integrating. So to resolve your issue change the "odeEvent" definition as follows:
E = odeEvent("EventFcn",@(t,Y,P) impactEvent(t,Y,P),"Direction","ascending","CallbackFcn",@(te,Ye,ie,P) impactEventCallback(te,Ye,ie,P),"Response","callback");

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 App Building 的更多信息

标签

产品


版本

R2024a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by