Edit Code Initialization under Mask editor
显示 更早的评论
I am creating the mask for my simulink block and I need to add the Initiallization code to it. Unfortumatelly I can't edit (add) code within the mask editor; it's grayed and not editable, disabled.
How can I access this, and add the initialization code to it?
Thank you.
采纳的回答
Hi Jack,
I faced a similar problem and found that there are two ways to save callbacks: either within the mask or in a separate callback file. It is possible that your Mask Editor is set to "Callback file" under "Switch Callback Mode." If you change this setting to "Mask," you should be able to edit the initialization code directly in the editor. I have attached an image to guide you through this process.
I hope this helps resolve the issue!
2 个评论
Jack Daniels
2025-1-8
移动：Fangjun Jiang
2025-1-17
Hello,
I did as you suggested. The code editor is not grayed but still disabled, not accessible and not possible to edit.
then it's neeed to click "+" to start the code edit to be accesibale/editable :)
Thanks for suggestion and point me to the right direction!
SIRENGO
2026-2-24，6:37
I benefitted from this advise too. Thanks a lot.
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Create Block Masks 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
