A few basic Simulink/Simscape questions
显示 更早的评论
In the past I've generally used Simulink simulations for short bursts of transient analysis.
I was curious if it were possible to use it more like LabView, where a simulation can also run forever (tstop = inf), and you can interact with and modify the setup in run time by pushing buttons (opening and closing SimScape circuits).
Regarding memory, I would not want to store all time data. It would be good to store the trailing 10000 points. I'm not sure how to do that either.
1 个评论
Matthew Mishrikey
2025-1-16
Here is something I just threw together that does what I think I need. Not sure how to handle the memory though. If there are a lot of measurements, the memory would fill pretty quickly.
采纳的回答
Fangjun Jiang
2025-1-16
0 个投票
run forever (tstop = inf)
Yes. Set the simulation stop time to be inf
store the trailing 10000 points
Yes. Limit the data points of Scope or data logging.
interact with and modify the setup in run time by pushing buttons
Yes with limited capability. Certain block parameters can be changed while the simulation is running and it will take effect right after change.
2 个评论
Matthew Mishrikey
2025-1-16
Fangjun Jiang
2025-1-16
编辑：Fangjun Jiang
2025-1-16
I don't think the memory will be filling up. Otherwise, it does not make sense. I've been running some simulation for a very long long time.
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Communications Toolbox 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
