How to calculate only several frequency with FFT ?

5 次查看（过去 30 天）
xd
xd 2025-1-17
编辑： Paul 2025-1-22
Almost all cases, 1st, use FFT2 transfer to frequency field all , then to analysis like filter.
If I know only some frequecy are need,
Is it possible to calculate only several frequency not all frequencies with FFT ?
If OK, How to do？
for example, if ther are 512 data points, then will get 512 data points at frequency field, but I only need 0~50Hz,
How to tall FFT no need to calculated those data more than 50Hz ?
Like sparse , but source data are not sparse, the transfer target at freq domain is sparse .

请先登录，再回答此问题。

采纳的回答

Mathieu NOE
Mathieu NOE 2025-1-17
移动：Matt J 2025-1-17

更多回答（1 个）

Paul
Paul 2025-1-17
If the desired frequenices are a subset of those that correspond to the DFT as computed by fft, I'd imagine in many cases there won't be a noticeable problem to call fft and then extract the desired subset of the results.
If the desired frequencies are not a subset of the DFT frequencies (or even if they are), then use freqz.
  2 个评论
xd
xd 2025-1-22
编辑：xd 2025-1-22
freqz is for special filter, not for calculate any a few freq.
I don't know is it possible for gereral calculation ...
Paul
Paul 2025-1-22
编辑：Paul 2025-1-22
Ran in:
freqz can be used to compute arbitrary samples of the DTFT of any finite duration signal. The DFT samples are at specific frequencies of the DTFT.
To demonstrate, use freqz to compute the DTFT of x and show the DFT are samples of that.
rng(100);
x = randn(1,100);
Ts = 0.01;
xdft = fft(x);
wdft = (0:99)/100/Ts;
[h,w] = freqz(x,1,8192,'whole',1/Ts);
figure
plot(subplot(211),w,abs(h));
hold on
stem(wdft,abs(xdft))
plot(subplot(212),w,angle(h));
hold on
stem(wdft,angle(xdft))
The third argument to freqz can be used instead to specify specific frequencies of interest.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Transforms 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by