MATLAB Simulink Task 5 Power Systems Simulation Incorrect Output Description
显示 更早的评论
I'm working on the MATLAB Simulink Power Systems Simulation Onramp, specifically Task 5. I changed the Wye-Connected Load block component structure to Series RL and set the default value to 12∠0° (A) for inductive reactive power, as required. I also used the filter from the previous task to extract the reactive power from the Q port of the Power Sensor and connected the filtered measurement to the Signal Assessment block. However, I still receive an incorrect output error.
Could anyone help identify what might be wrong?
回答（1 个）
Cris LaPierre
2025-2-22
0 个投票
This is happening because the default value for one of the Wye-Connected Load block parameters has changed in R2024b.
Under Parasitics, change the Parasitic parallel conductance to 0. Keep the units as 1/Ohm.
Now submit.
1 个评论
类别
在 帮助中心 和 File Exchange 中查找有关 Simulink 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
