Hey, There is an error I faced with Task 7 of Project - Peregrine Falcon Dive in Self-paced Simulink Onramp course.

8 次查看（过去 30 天）
Venkata
Venkata 2025-4-4
评论： CHANDRA BABU GUTTIKONDA 2025-8-13，5:23
Hello, everyone, The solution is what the assignment is expected, but I am facing an error in task 7 of Project - Peregrine Falcon Dive, where the error says as follows :
"Task 7: Sorry, that is not correct. Please review the task instructions and the assessment block output."
but from the Model assessment it shows "no input is required for this task." you can check this from Image_1.
I did connect both v,H to the scope and checked the soluton, it matches with the required solution. Any help is welcome and thanks in advance.
  1 个评论
CHANDRA BABU GUTTIKONDA
CHANDRA BABU GUTTIKONDA 2025-8-13，5:23
you have to connect the scope from the line v and h . can you please reshare the picture . did you assigned the values in small letters only ?? if not change the into small letters

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Ishaan
Ishaan 2025-4-25
Hey,
I notice that you are facing an error in task 7 of the Part 2 of Peregrine Falcon Dive Project. As per the screenshot you shared, the “Are the signals v and h connected to the Scope?” requirement is not satisfied. But clearly that’s not the case.
Additionally, I observe that you do not have a “square function block” and a “switch block” in your model. These were necessary for solving the previous blocks. To be clear, I did test the task without the “square function”, “switch” and “gain” block, and all 3 requirements were met when I connected the scope block to “h” and “v”. Hence, the missing blocks should not be the sole issue.
Although the screenshot you attached isn’t very clear, upon closer inspection the block under the gain block does not appear to be a “product block”. Task1 had a “product block” there for multiplying “v” and the output of “switch block”.
I would recommend you reset the model from the left sidebar and attempt the task/project again.
In case that does not resolve the issue, please share a clear screenshot of the same.
P.S. I have attached a screenshot from my attempt (accepted) of the same task for your reference.
scope output

类别

在 Help Center 和 File Exchange 中查找有关 Dependency Analysis 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by