The ‘Model Advisor’ only displays the checks for your installed products. In this case, all the checks mentioned above are part of ‘Embedded Coder’ as mentioned in the documentation below:
The issue in this case might be that ‘Embedded Coder’ has not been installed on your system, or a license key is not available. You can run the following command in the ‘MATLAB command Window’:
ver
to check if the required product has been installed. If not, please install ‘Embedded Coder’. Also, make sure that you have a license key available for this product, otherwise, the respective checks will be skipped. After the installation, run the following command in the ‘MATLAB Command Window’:
Advisor.Manager.refresh_customizations
to ensure the additional checks are updated in the ‘Model Advisor’ as per the newly installed products.
I hope this helps!
