Mux to Bus error message
显示 更早的评论
I'm getting a strange error when trying to run one of our models in simulink: I'm being told 'The block diagram 'Filename' uses bus signals. However, the 'Mux blocks used to create bus signals' diagnostic is not configured to 'error'. To prevent modeling errors:'
Why am I getting an error message for something I've deliberately turned off? Due to the way the model interfaces with our software it has to have a mux creating a bus otherwise it won't work so I can't replace the muxes with buses.
1 个评论
Kevin Quigley
2017-5-16
You accepted the answer, but it's unclear if using the suggested setting solved your problem or it prevented you from using your model as implied in your question.
What was the outcome of setting this to 'error'? Did you have to rework the model?
采纳的回答
Vinod Sudheesh
2015-5-27
6 个投票
Hi Matthew,
To avoid this error please navigate to
Model Configuration Parameters (Ctrl+E) >> Diagnostics >> Connectivity >> Mux blocks used to create bus signals:
and set the value to "error".
Please note that this diagnostic needs to be set to "error" whenever there is a bus signal in the Simulink model so as to ensure that there will not be any problems with block connections while compiling the model.
Hope this helps!
Vinod
9 个评论
Walter Roberson
2016-8-28
Sam Samat comments,
Great help for newbie
Saif
2017-1-6
Great help, Thanks
mouli thirumalasetty
2017-7-2
helpful thanks
Kamal Ebrahimi
2017-11-19
THANKS A LOT
yousef naghibzadeh
2018-1-27
thank you
wang claude
2018-3-22
thanks a lot, great help
Avinash Kishore
2018-4-4
Thank you. It helps
MOHAMMED AL-MAHMODI
2020-12-31
Thanks
Mujtaba Syed
2021-10-13
thanks man
更多回答（1 个）
Gagandip Singh Khanduja
2018-7-19
0 个投票
Thank you for useful information
类别
在 帮助中心 和 File Exchange 中查找有关 General Applications 的更多信息
产品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
