Cannot find SoCData and rteEvent datatypes characteristics

Question

Sergei 2025-5-12

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2177094-cannot-find-socdata-and-rteevent-datatypes-characteristics

评论： Sergei 2025-6-2

采纳的回答： Vinay

Dear all,

I was trying to figure out the following about SoCData datatype:

1) What are its dimensions?

2) Is this real or complex signal?

Could you, please, help me to find information about this? Same qustion concerning rteEvent datatype. These datatypes are output datatypes or AXI4-Stream to Software block. I also had a feeling that these might be messages, not signals. Is this correct or not?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Vinay 2025-5-15

2
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2177094-cannot-find-socdata-and-rteevent-datatypes-characteristics#answer_1565261

Hi @Sergei

The "SoCData" datatype is an "AliasType" that creates an alias for the built-in "double" type. You can run "SoCData" in the MATLAB command window to view its properties.

The "rteEvent" datatype is a "bus" type with "DataScope" set to "auto". To see its properties, run "rteEvent" in the command window.

For more information, please refer to the documentation below.

I hope this helps.

3 个评论
显示 1更早的评论隐藏 1更早的评论

Vinay 2025-5-15

编辑：Vinay 2025-5-15

Hi @Sergei

Below are the properties for both data types:

Sergei 2025-5-15

Thank you

I just realized that I should have ran "SoCData" in command window with the model open (as aliases only exist when you create them, e.g. in model, it is not some general data type accessible everywhere in matlab)

请先登录，再进行评论。

Answer 2

Jerome Chevalier 2025-5-28

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/2177094-cannot-find-socdata-and-rteevent-datatypes-characteristics#answer_1565550

Hi @Sergei

To add to @Vinay answer:

In SoC Blockset, SoCData is used as data type for message lines between FPGA and Processor blocks. SoCData is an alias to a double and it does not directly carry the value exchanged, but instead an id to an internal storage space (which is opaque and not visible to the user).

SoC Blockset blocks outputing SoCData must be connected to a SoC Blockset blocks accepting SoCData as input: For example, AXI4-Stream to Software block must be connected to Stream Read block.

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Sergei 2025-6-2

Thank you for clarification! This is a good information to add.

请先登录，再进行评论。