PV array with DC/DC Buck Converter

29 次查看（过去 30 天）
Mohammad Iqbal Amir
回答： Sabin 2025-8-5
I did a simulink simulation for PV array with DC/DC Buck Converter to charged the battery. But i after try to simulate it i found that my PV voltage is close to my Output Voltage. It seems like its not a correct results. The parameter of PV Voc (19V), Isc (0.124A) ,Vmp (15.4V), Imp ( 0.1A) is set by my ownself from a solar panel datasheet. While the converter should step down the voltage to 8.4V (2s lithium ion battery). P&O MPPT already been implement in this circuit.

请先登录，再回答此问题。

回答（1 个）

Sabin
Sabin 2025-8-5
Without the actual model we cannot point to any specific problem. It may be parameterization or design of MPPT. A good starting point in learning about PV systems and how to control them is this example in Simscape Electrical:
https://www.mathworks.com/help/sps/ug/stand-alone-solar-pv-ac-power-system-with-battery-backup.html

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by