Error using Git source control with Simulink
显示 更早的评论
I'm using MATLAB 2023a and Git for a Simulink Project (.prj). The project contains a "main" Simulink model that references several other models using Model Reference blocks. Most of these models also have test harnesses.
When I try to compare my model against its ancestor (or any Git revision), I get the following error pop-up:
Cannot open test harness 'name-of-test' as another model with the same name is currently open. Please close the other model before opening this harness
Additionaly, when comparing the "main" model, the comparison results show only changes in test harnesses but no differences in the actual model itself.
Important notes:
- I am not editing the test harness
- I don't have any harness open during the comparison
- This issue affects only models with test harnesses
Has anyone run into this behaviour? Is there a way to configure MATLAB/Simulink (or Git) to ignore test harness models during comparison so that only actual model changes are shown?
采纳的回答
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Source Control 的更多信息
Translated by 
