Changing the size and position of the simulink block
207 次查看(过去 30 天)
显示 更早的评论
How can I change the position and size of the simulink block from the matlab command window?
sys = 'testmodel';
new_system(sys);
load_system(sys);
add_block('Simulink/Commonly Used Blocks/Subsystem',[sys '/subsystem])
add_block('builtin/Outport','testmodel/ouput1','MakeNameUnique','on')
now i have created one subsystem and one outport.
what are the commands i need to use for changing the model size and position of the block?
Thanks a lot
0 个评论
采纳的回答
Azzi Abdelmalek
2015-5-22
set_param('Model_Name/Block_Name','Position',[50 50 200 100])
5 个评论
Nabil akroud | نبيــل عكرود
2021-11-16
编辑:Nabil akroud | نبيــل عكرود
2021-11-18
by using get_param
- get_param(Object,Parameter)
for example, the following code will open the vdp example and will give you the position of the gain block (Mu) inside it:
open_system('vdp')
get_param('vdp/Mu','position')
Abdelghafar Elkhaoui
2022-3-27
@Slimeni Omar to get the position of any block in simulink model :
get_param('Model_Name/Block_Name','Position')
更多回答(1 个)
Prerana Ozarkar
2019-3-5
编辑:Prerana Ozarkar
2019-3-5
You need to use following command:
get_param(pathOfsystem, 'Position')
this will retuen you a 1X4 matrix in which positions will be stored in a manner [X Y Width Height]
1 个评论
Manuel K
2022-11-8
It's actually a: vector of coordinates, in pixels: [left top right bottom]
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Programmatic Model Editing 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!