Hi, I tried to use fmincon but I received the message. How I can overcome this problem?

70 次查看（过去 30 天）
Muna Shehan
Muna Shehan 2015-5-24
编辑： Walter Roberson 2015-6-28
" fmincon stopped because the size of the current step is less than the default value of the step size tolerance but constraints are not satisfied to within the default value of the constraint tolerance "

请先登录，再回答此问题。

采纳的回答

Walter Roberson
Walter Roberson 2015-5-24

更多回答（2 个）

Mark Stone
Mark Stone 2015-5-25
编辑：Mark Stone 2015-5-25
If you provide reproducible code, i.e., all input data, options, etc., perhaps someone can offer more concrete help.
As has been previously suggested, poor scaling may be at least part of your problem. But another possibility is that you are using incorrect derivatives (gradient of constraint and maybe objective function). Are you supplying gradients, or is it using numerical differentiation? Have you used the derivative check option (actually, I'm not sure that checks constraint gradient, though).
It may also be the case that you can succeed from a different starting point. In general, you may have better luck with tricky constraints if you use the active-set, or maybe better yet, SQP algorithm than the other algorithms.
Can you show the output using iter-detailed?
  1 个评论
Muna Shehan
Muna Shehan 2015-6-28
编辑：Walter Roberson 2015-6-28
Hi, I had downloaded a code from File exchange http://www.mathworks.com/matlabcentral/fileexchange/40504, and it had been executed efficiently first time. When I tried to re-execute it again, I faced an error message:
Local minimum possible. Constraints satisfied.
fmincon stopped because the size of the current step is less than the default value of the step size tolerance and constraints are satisfied to within the default value of the constraint tolerance.
I am not sure how I can show you the result file, so I'll be thankful if you sent your email to attache the result file in order review the error message.
Best Regards

请先登录，再进行评论。

Muna Shehan
Muna Shehan 2015-5-25
Thanks for your response. If the function suffers from numeric round-off can avoid this problem.
  1 个评论
Walter Roberson
Walter Roberson 2015-5-25
recenter, re-scale. http://www.mathworks.com/matlabcentral/newsreader/view_thread/239616
Note that when you recenter and rescale that you will need to adjust your constraints and you may need to adjust your function.
There are a lot of cases that recentering and rescaling will not fix, and a different approach is needed.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Solver Outputs and Iterative Display 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by