Unable to build a standalone executable to simulate the model 'NAME OF MODEL' in accelerator mode.
4 次查看(过去 30 天)
显示 更早的评论
Hi guys,
I am using matlab 2105a 64 bits, and I have problems to run my simulink model in accelerator and rapid accelerator mode. The error is:
NMAKE : fatal error U1073: don't know how to make 'C:\Program' Stop.
C:\Users\mnievesp\Documents\MATLAB\slprj\raccel\FB_DC_DC_converter_V2_trash>echo The make command returned an error of 2 The make command returned an error of 2
C:\Users\mnievesp\Documents\MATLAB\slprj\raccel\FB_DC_DC_converter_V2_trash>An_error_occurred_during_the_call_to_make "An_error_occurred_during_the_call_to_make" no se reconoce como un comando interno o externo, programa o archivo por lotes ejecutable.
Curiously, I have installed the same matlab/simulink in other laptop and runs fine in accelerator mode. Anybody could give me a hand, please?
Best regards
0 个评论
回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!