goto error when using more than one Single Phase Dynamic Load Block
显示 更早的评论
hi I want to modeling IEEE 37 bus with simulink i want to modeling three phase unblanced constant current so i used Single Phase Dynamic Load Block but when I using more than one block i recive multipile goto error
1 个评论
Xinglei REN
2016-11-15
Could you share your Simulink model with me? I only want to use it evaluate my calculation. Thank you!
采纳的回答
Sebastian Castro
2015-6-9
2 个投票
This problem no longer happens in the latest version (R2015a), but I tried on an older version and that was indeed the case.
Not sure how safe this is, but I could resolve the issue by right-clicking the block, selecting "Properties", going to the "Callbacks" tab, and deleting the text in the "CopyFcn" callback. Apparently that callback modifies the names of a Goto block in the Controlled Current Source inside the block, which causes a conflict when you have multiple of them dragged in.
- Sebastian
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Modeling 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
