"verify hardware selection" in fixed-point advisor

2 次查看（过去 30 天）
Safiya
Safiya 2015-6-15
回答： Andrew Schenk 2015-6-16
Hello,, in the fixed-point advisor, if we don't choose hardware (verify hardware selection) it does not proceed. If I dont like to target to any harware but target is vhdl code for cadence layout etc.

请先登录，再回答此问题。

回答（1 个）

Andrew Schenk
Andrew Schenk 2015-6-16
You can select Device vendor "Generic" and Device type "Custom" and then continue to use the Fixed-Point Advisor.
Alternatively, you can just leave the Fixed-Point Advisor at this step, return to the Fixed-Point tool and run the Data collection section, then the Propose word lengths section.

类别

在 Help Center 和 File Exchange 中查找有关 FPGA, ASIC, and SoC Development 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by