how can I make the signalbuilder run

2 次查看（过去 30 天）
Ahmed BOULMANE
Ahmed BOULMANE 2015-6-22
评论： Ahmed BOULMANE 2015-6-25
can I run the signalbuilder through Matlab script's ? if yes, so how ?
thank you

请先登录，再回答此问题。

回答（3 个）

Abhiram Bhanuprakash
Hi Ahmed,
You can use the sim command to run any Simulink model using command line API. Documentation here
So, you can create a Simulink model with a signal builder block and then use sim to run it by command line.
You can also set block parameters of a Simulink block using set_param. You can query them using get_param. You can use these functions on the signal builder block to set or query block parameters.
Hope this helps,
Cheers!
Abhiram
  1 个评论
Ahmed BOULMANE
Ahmed BOULMANE 2015-6-22
thank you Abhiram,
the problem is that I'm looking to make run a single group among those that exist in the signalbuilder, knowing that we have 60 groups.

请先登录，再进行评论。

Ahmed BOULMANE
Ahmed BOULMANE 2015-6-24
Heeeeelllppp !!
Anthony Poulin
Anthony Poulin 2015-6-24
编辑：Anthony Poulin 2015-6-24
Hello,
Do you want to select a specific group of your signal builder?
If YES, use the command: signalbuilder(block, 'activegroup', index) which sets the active group with the index that you specified. Then run your simulation, with the "sim" command (like Abhiram says).
  1 个评论
Ahmed BOULMANE
Ahmed BOULMANE 2015-6-25
thank you :) it works good (y) otherwise, have you any idea about how can I load the index from a .txt file

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by