How to extract phase and amplitude information from FFT?

70 次查看（过去 30 天）
Mayank Lakhani
Mayank Lakhani 2015-6-26
评论： Adam 2017-7-14
I am doing signal processing of radar data. I applied butturworth bandpass filter and applied fft to the radar data.I want to know how to extract the phase and amplitude information of radar data so i can add it to my ideal radar simualation and make it non ideal :D . Thanks
load('fb2040'); % loading the data
x = fb2040(3,:);
y_filt = filter(b,a,x); % filtering the received signal
nfft = length(y_filt);
res = fft(y_filt,nfft)/ nfft; % normalizing the fft
f = fs/2*linspace(0,1,nfft/2+1); % choosing correct frequency axes
res = res(1:nfft/2+1);
figure, plot(f,abs(res));
xlabel('Frequency in MHz');ylabel('Amplitude');
return

请先登录，再回答此问题。

采纳的回答

Adam
Adam 2015-6-26
If you want the phase and amplitude for different frequencies then these are just:
angle( res );
real( res );
or
abs( res );
if you want the magnitude rather than amplitude.
  2 个评论
Peter Mbamaluikem
Peter Mbamaluikem 2017-7-13
Hi, Adam what if there are several frequencies and one is to extract the magnitude of one say 60Hz. what will the code be?
Adam
Adam 2017-7-14
'res' in the above code is a vector of results corresponding to the frequencies in 'f' in the original code in the question so just find the 'f' that is closest to 60Hz and take the magnitude of that value rather than the whole vector.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Detection, Range and Doppler Estimation 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by