Sample time Propagation Error - The sample time after propagation is [0, 0]. Enter a discrete sample time

Question

Vignesh Venkatachalam 2015-6-30

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/225917-sample-time-propagation-error-the-sample-time-after-propagation-is-0-0-enter-a-discrete-sample

评论： Amin Ahmed 2016-5-28

Hello,

I'm getting the following error,

The sample time after propagation is [0, 0]. Enter a discrete sample time in ....... Zero-Order Hold1

I checked the entire model, all blocks have a sample time of 0.01 or -1(inherited) and also there are no continuous states within the model. I'm not sure why this error is coming up.

The above error points to Zero-Order Hold block which has a sample time of -1 (inherited), if I change that to 0.01 the simulation is running, but there are lot of places within my model which has inherited sample time changing each and every block would be cumbersome.

I appreciate any suggestion to overcome this issue.

Thank you!

Vignesh

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Adam Hug 2015-7-2

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/225917-sample-time-propagation-error-the-sample-time-after-propagation-is-0-0-enter-a-discrete-sample#answer_184867

Hi Vignesh,

Here is the doc page on how Simulink propogates sample times:

http://www.mathworks.com/help/simulink/ug/how-propagation-affects-inherited-sample-times.html

I suspect that you are feeding the Zero-Order hold block a continuous signal. According to the chart, this may be confusing Simulink when it comes time for it to assign sample times to each block.

2 个评论
显示无隐藏无

Vignesh Venkatachalam 2015-7-6

Thanks Adam that was very helpful, You were right, at a particular place I was feeding in a continuous signal, after changing that the above issue is resolved.

Thanks again, I really appreciate it.

Amin Ahmed 2016-5-28