How to trigger analog inputs on a threshold levels using session based interface?

2015 7 13
2 个回答
更新时间：2015 12 7
5 次查看（30 天）

0 个投票

Hello,
I am using Matlab 64 bits for data acquisition using NI instruments. I am acquiring the signal from an analog input. I would like to trigger the acquisition when that signal reaches a certain threshold. I am not able to find any help on that using session-based interface (the only help is about using digital triggers). I know it was possible using legacy commands, but I am not sure how to adapt it to session-based commands.
Thank you for your help

1 个评论
显示 -1更早的评论 隐藏 -1更早的评论

Oskar
Oskar 2015-8-25
Hello! I am also interested in this specific question, any solution yet? Best regards, Oskar

请先登录，再进行评论。

请先登录，再回答此问题。

回答（2 个）

Ke Feng
Ke Feng 2015-9-23

0 个投票

I am also looking for a solution. This is not hard with legacy interface, but we are now forced into the session based interface.

类别

在 帮助中心 和 File Exchange 中查找有关 Data Acquisition Toolbox Supported Hardware 的更多信息

标签

回答：

Vinod
Vinod
2015-12-7

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by