NI 9263 cDAQ1 gives the output signal just between -5 to +5 Volt instead of +/-10, using Matlab ICT

3 次查看（过去 30 天）
Tamás Ther
Tamás Ther 2015-7-14
During a laboratory test I use an NI 9263 instrument for giving +/-10 V to an MTS MicroConsole. Somehow, the qued output data, that is between -10 and +10 Volts, just appeared to cause displacements that would belog to +/-5 V output signal. It seems, that the used MatLab functions halves my signal... I have not changed the range of the instrument (as it states as well), and the controlling program given with the NI device gives good results, as well, as a simple 9V baterry. This why I would say, that the error is somewhere inside the code...
if true
% controlling NI 9263 DAQ
% function
x=0:0.001:10; %--> signal is 10s long
y=sin(x)*9; %--> sine with a +/-9 amplitude
% plot(x,y);title('signal');
% Getting the device
daq.getDevices()
% result:
% cDAQ1Mod1: National Instruments NI 9263
% Analog output subsystem supports:
% -10 to +10 Volts range
% Rates from 0.0 to 100000.0 scans/sec
% 4 channels
% 'voltage' measurement type
%
% This module is in chassis 'cDAQ1', slot 1
%
% que the data
s = daq.createSession('ni');
s.addAnalogOutputChannel('cDAQ1Mod1', 'ao0', 'voltage'); %in R2014b 'Voltage' !!!
s.queueOutputData (y');
% start the signal
s.startForeground;
% end of signal
s.removeChannel(1)
end
Thenk You for any help! Bests!

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 MATLAB Support Packages 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by