Example c2000 concerto on the leds
显示 更早的评论
Hi,
I tried this example of the LEDs on Matlab.
I have a problem in managing the LEDs . From datasheet card there is no correspondence with the LEDs indicated by example. Infact there is led 1 with GPIO 70 but not LED 2 .
Also, if I try to use the C28x processor to turn on the LED 3 ( GPIO71 ) nothing happens .
Who can help me ?
Thank you
Luigi
1 个评论
Andres
2016-6-14
I have the same issue. I tested the board using CCS Studio and LED2 correspond to GPIO 70. So I think the model is ok.
Also If I follow the M3 example everything works . The issue comes when you try to load the C28x model into the processor. Is not loading at all. These are the last two lines I got form the diagnostic viewer. ### Successful completion of code generation for model: led_blink_f28m35_c28 Build process completed successfully ------ I think it should attempt to load and Run but nothing happens.
回答（1 个）
Andres
2016-6-15
0 个投票
This Worked for me :
Reinstall the support packages for C2000 Concerto
Install the latest version of ccs studio.
Change in configuration parameters in the code generation pane, the Toolchain settings , Toolchain = Texas Instruments Code Composer Studio V6 (C2000)
I hope this can help.
类别
在 帮助中心 和 File Exchange 中查找有关 Texas Instruments C2000 F28M3x Concerto Processors 的更多信息
2015-8-11
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
